Evaporative Cooler Service Before Summer
Evaporative cooling is the one system almost nobody thinks about until the first genuinely hot day. Which is a problem, because it's also the system most affected by the nine months it spends not being used.
Your split system lives in a relatively protected spot and runs on and off through the year. Your evaporative cooler sits on the roof, in full sun, through every frost, storm and westerly Melbourne can produce, with water sitting in it or drained out of it, doing nothing at all from about March to November.
Key points
- Evaporative coolers sit unused from roughly March to November — the downtime causes more problems than the running.
- Pads stiffen and scale up, water distribution blocks, and pumps that have sat dry frequently will not restart.
- Booking in spring costs the same as January but avoids the first-hot-day demand spike and parts shortages.
- It is roof work with live electrical and water — not a DIY job.
That downtime is the problem, not the running.
What actually happens over winter
The pads degrade. Cooling pads are consumables. They collect dust and mineral deposits from every litre of water that's passed through them, and Melbourne's water leaves scale behind. Over a season the pads stiffen, channel, and stop wetting evenly. A pad that isn't wetting evenly isn't cooling — air takes the path of least resistance straight through the dry section and arrives warm.
Mineral scale blocks water distribution. The distributors that spread water across the top of the pads block up with scale and sediment. You end up with wet patches and dry patches instead of an even curtain of water.
The pump seizes. A water pump that's sat dry for nine months frequently won't start, or starts and runs badly. This is the single most common first-hot-day failure we attend.
Bearings and motor. Fan bearings dry out and the motor sits exposed to weather. Both fail more often after a long idle period than during use.
The drain and float. Drain valves stick, floats stick, and you either can't fill or can't empty. A cooler that won't drain properly sits with stagnant water in it, which is a water quality issue as well as a corrosion one.
Dust and vermin. A roof-mounted box with openings is attractive to birds, rodents and wasps over winter. We find nests every single season.
The roof penetration. Flashing and seals around the unit degrade in UV. A leak here shows up on your ceiling, not on the unit.
Why spring, not January
Two reasons, and both are practical.
The first is that if something has failed, you find out in September when it's easy to book a technician and easy to get parts — rather than on the first 38°C day, when every evaporative cooler in Melbourne has been switched on within the same six hours and the whole trade is booked out. The demand spike on the first hot weekend of summer is genuinely extreme, and no amount of goodwill gets around it.
The second is that pads and pumps are ordered parts. In September, a replacement pad set is a few days. In peak season, supply tightens across the whole state at once.
Getting it done early costs the same as getting it done late. It just works.
What a service should include
- Pads inspected and replaced where required — not just hosed off
- Water distribution system cleaned and flow checked across the full pad area
- Pump tested under load and current checked
- Tank drained, cleaned and descaled
- Float valve, drain valve and water level set correctly
- Fan, bearings and motor checked, current draw measured
- Electrical connections and controls tested
- Ductwork and outlets checked
- Roof penetration, flashing and unit mounting inspected
- Written report of findings
That last point matters. Ask for the report — it tells you the condition of the pads and pump, which is how you plan for a replacement rather than being surprised by one.
Please don't do this yourself
It's roof work. Every year people are seriously injured falling from roofs doing their own maintenance, and evaporative coolers are typically mounted on pitched tile or metal roofs that are unforgiving when wet or brittle in heat. There's also live electrical and water in the same box.
If your system is more than about ten years old and the pads and pump are due, it's also worth having a conversation about whether a replacement or a change of system makes more sense than another round of parts.